AVSL 153.118 MMD-PC1 PC KIT - Manual (Page 3)

P ramming Manual Programming Manual
1: General Information
You can operate the sign in two ways:
 By using a hand-held remote control
 By using personal computer
1.1: Using a remote control to operate your sign
A remote control is a hand-held keyboard used to operate the sign. This manual shows you how to
program messages on your sign using a remote control.
1.2: Using a computer to operate your sign
To do this, you’
ll need special connectors and computer software as following shown:
LED Display
Signal Cable
Power Adaptor
To Power Source
To one of the PC’ s
COM (RS232) ports
Note: Do not connect a telephone to the sign’ s RS232 jack.
Note: Do not use ordinary telephone wire to connect the sign to a computer
Note: Use only the power supply that came with the sign.
1.3: Attaching your sign to a surface
Your sign can be mounted to a wall.
Note: This sign is intended for indoor use only.
Note:

Do not mount or attach the power supply to anything.
 Do not let the power supply hang loose.
 Place the power supply on a flat surface where no chemicals or liquid, such as
water, will contact it.
 Plug the power supply into an easily accessible electrical outlet
Wall mount
1. Attach the mounting brackets to the wall or surface.
2. Attach the sign to mounting brackets using hardware as shown below.
3. Plug the power cord into the sign and into an outlet.
Bracket Power cord
Brack et
Screw Washer
Top View
Front View
Washer
Sc rew
－
Page3
-