6 storage configuration, Storage configuration -22, Dma mode [auto – Asus Rampage II Extreme User Manual
Page 104: Smart monitoring [auto, 32bit data transfer [enabled, Sata configuration [enhanced

3-22
Chapter 3: BIOS setup
DMA Mode [Auto]
Selects the DMA mode. Configuration options: [Auto] [SWDMA0] [SWDMA1]
[SWDMA2] [MWDMA0] [MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2]
[UDMA3] [UDMA4] [UDMA5]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
SATA Configuration [Enhanced]
Configuration options: [Disabled] [Compatible] [Enhanced]
Configure SATA as [IDE]
Sets the configuration for the Serial ATA connectors supported by the
Southbridge chip.
If you want to use the Serial ATA hard disk drives as Parallel ATA physical
storage devices, keep the defaul setting [IDE].
If you want the Serial ATA hard disk drives to use the Advanced Host
Controller Interface (AHCI), set this item to [AHCI]. The AHCI allows the
onboard storage driver to enable advanced Serial ATA features that increases
storage performance on random workloads by allowing the drive to internally
optimize the order of commands.
If you want to create a RAID 0, RAID 1, RAID 5, RAID 10, or the Intel
®
Matrix
Storage Technology configuration from the Serial ATA hard disk drives, set
this item to [RAID].
3.4.6
Storage Configuration
The items in this menu allow you to set or change the configurations for the SATA
devices installed in the system. Select an item then press
configure the item.
BIOS SETUP UTILITY
Main
Storage Configuration
SATA Configuraton
[Enhanced]
Configure SATA as
[IDE]
Hard Disk Write Protect
[Disabled]
SATA Detect Time Out (Sec)
[35]
Options
Disabled
Compatible
Enhanced