Asus Rampage II Extreme - Manual (Page 110)

3-28 Chapter 3: BIOS setup
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
Onboard Device Configuration
Onboard Device [Standard]
High Definition Audio [Enabled]
Front Panel Type [HD Audio]
J-Micron eSATA/PATA Controller [Enabled]
Controller Mode [IDE]
Marvell LAN1 [Enabled]
Marvell LAN2 [Enabled]
LAN Boot ROM [Disabled]
Onboard 1394 Controller [Enabled]
Enable or Disable
High Definition Audio
Controller
BIOS SETUP UTILITY
Advanced
3.5.3 Onboard Device Configuration
Onboard Device [Standard]
Allows you to disable the onboard device controllers.
Configuration options: [Standard] [Disabled]
High Definition Audio [Enabled]
Allows you to enable or disable the High Definition Audio Controller.
Configuration options: [Enabled] [Disabled]
Front Panel Type [HD Audio]
Allows you to set the front panel audio connector (AAFP) mode to legacy
AC’97 or high-definition audio depending on the audio standard that the front
panel audio module supports. Configuration options: [AC97] [HD Audio]
J-Micron eSATA/PATA Controller [Enabled]
Allows you to enable or disable the onboard JMicron eSATA/PATA controller.
Configuration options: [Enabled] [Disabled]
Controller Mode [IDE]
This item appears only when you enable the previous item.
Configuration options: [IDE] [AHCI]
If you want to use the hard disk drive as a Parallel ATA physical storage
device, keep the defaul setting [IDE].
If you want the hard disk drive to use the Advanced Host Controller Interface
(AHCI), set this item to [AHCI].
MarvelI LAN1/2 [Enabled]
Allows you to enable or disable the onboard Marvell LAN port1/2.
Configuration options: [Enabled] [Disabled]