Asus MAXIMUS VI IMPACT - Manual (Page 110)

3-26 Chapter 3: BIOS setup
Chapter 3
CPU Analog I/O Voltage Offset Mode Sign [+]
[+] To offset the voltage by a positive value.
[-] To offset the voltage by a negative value.
CPU Analog I/O Voltage Offset [Auto]
Allows you to set the amount of voltage fed for the analog portion of the input/output on
the processor. Increase when increasing DRAM frequency. Use the <+> or <-> key to
adjust the value. The values range from 0.001V to 0.999V at 0.001V increment.
CPU Digital I/O Voltage Offset Mode Sign [+]
[+] To offset the voltage by a positive value.
[-] To offset the voltage by a negative value
CPU Digital I/O Voltage Offset [Auto]
Allows you to set the amount of voltage fed for the digital portion of the input/output on
the processor. Increase when increasing DRAM frequency. Use the <+> or <-> key to
adjust the value. The values range from 0.001V to 0.999V at 0.001V increment.
SVID Control [Auto]
Set this item to [Enabled] when overclocking. Disabling this item prevents the processor from
communicating with the external voltage regulator.
Configuration options: [Auto] [Disabled] [Enabled]
Initial CPU Input Voltage [Auto]
Allows you to set the CPU Input Voltage during initial part of POST. Use the <+> or <-> key to
adjust the value. The values range from 0.800V to 2.440V at 0.010V increment.
Eventual CPU Input Voltage [Auto]
Allows you to set the Eventual CPU Input Voltage before the operating system loads. Use
the <+> or <-> key to adjust the value. The values range from 0.800V to 2.440V at 0.010V
increment.
DRAM Voltage [Auto]
Allows you to set the voltage for the system memory. Use the <+> or <-> key to adjust the
value. The values range from 1.20V to 2.40V at 0.005V increment.
PCH Core Voltage [Auto]
Allows you to set the core voltage for the PCH. Use the <+> or <-> key to adjust the value.
The values range from 0.70V to 1.80V at 0.00625V increment.
PCH VLX Voltage [Auto]
Allows you to set the PCH VLX voltage for the input/output on the PCH. Use the <+> or <->
key to adjust the value. The values range from 0.8000V to 2.0000V at 0.00625V increment.
VTTDDR Voltage [Auto]
Allows you to set the termination voltage for the system memory. Use the <+> or <-> key to
adjust the value. The values range from 0.6000V to 1.4000V at 0.00625V increment.