Asus MAXIMUS VI IMPACT - Manual (Page 104)

3-20 Chapter 3: BIOS setup
Chapter 3
ICC Ringback Canceller [Auto]
Set this item to [Enabled] to control the noise level at the Integrated Clock Controller.
[Enable] Allows a better High DMI Frequency O.C.
[Disable] Allows a better Low DMI Frequency O.C.
Clock Crossing VBoot [Auto]
Allows you to increase the value of the clock crossing voltage boot when the rising
edge of BCLK DN is equal to the falling edge of the BCLK DP. Use the <+> or <-> key
to adjust the value. The values range from 0.1V to 1.9V at 0.00625V increment.
Clock Crossing Reset Voltage [Auto]
Allows you to increase the value of the clock crossing reset voltage when the rising
edge of BCLK DN is equal to the falling edge of the BCLK DP. Use the <+> or <-> key
to adjust the value. The values range from 0.1V to 1.9V at 0.00625V increment.
Configuration options: [Auto] [0.1000] - [1.9000]
Clock Crossing Voltage [Auto]
Allows you to increase the value of the clock crossing voltage when the rising edge of
BCLK DN is equal to the falling edge of the BCLK DP. Use the <+> or <-> key to adjust
the value. The values range from 0.1V to 1.9V at 0.00625V increment.
BCLK Amplitude [Auto]
Allows you to adjust the magnitude of the BCLK (base clock).
Configuration options: [Auto] [+1] [0]
DMI Gen 2 [Auto]
Allows you to enable or disable the DMI (Direct Media Interface) Generation 2.
Configuration options: [Auto] [Enabled] [Disabled]
DMI De-emphasis Control [-6 dB]
Allows you to configure the De-emphasis control on DMI (Direct Media Interface).
Configuration options: [-6 dB] [-3.5 db]
SATA Drive Strength [Auto]
Allows you to set a value for SATA Drive Strength.
Configuration options: [Auto] [+10] - [-10]
PCIE Tuning
Internal Graphics [Auto]
Allows you to keep IGD enabled based on setup options.
Configuration options: [Auto] [Disabled] [Enabled]