Canon 550 EX - Manual (Page 73)

Wireless Manual Flash With Varied Flash Output
Press the < > or < > button to set
the flash output for B.
Press the < > button.
• C and the flash output display will blink.
Press the < > or < > button to set
the flash output for C.
Press the < > button to
register the settings.
73
After setting up the wireless flash system, you can set stroboscopic flash with
the master unit for wireless stroboscopic flash.
• The firing frequency and flash count will be the same for all slave units. They can be set by
following the procedure on page 46.
• Set the flash output of the slave units in the same way as for wireless manual flash. See page 71.
• To determine the proper exposure, take test shots and experiment.
7
8
9
10
• If there are only two slave units (A and B), steps 9 and 10 may be omitted.
• After you complete the settings, you can check the respective flash output for slave
units A, B, and C by pressing the < > or < > button.
• Press the master unit’s pilot lamp to test fire the slave units.
[4] Wireless Stroboscopic Flash
05. F073-E (51~) 02.4.1 2:12 PM Page 73