beautypg.com

Canon 550 EX User Manual

Page 59

background image

Wireless Flash Range

Check that the master unit’s pilot
lamp is lit and that the slave unit(s)
are recharged and ready.

• When a slave unit is ready, its AF-assist

beam blinks once per second.

Press the master unit’s pilot lamp
(test firing button) to fire a test flash.

• When the wireless transmission works, the

slave units fire at 1/64 output in the following
slave ID order: A, B, and C.

• If a slave unit does not fire, place it closer to

the master unit or angle the sensor more
toward the master unit and try again.

59

3

4

• In a wireless flash system, the flash mode (E-TTL autoflash, high-speed sync, manual

flash, stroboscopic flash), flash exposure compensation, flash exposure bracketing,
and other settings are all set with the master unit. The master unit transmits all these
settings to the slave units by wireless signals. Controlling slave unit(s) is the same as
controlling one on-camera Speedlite.

• A modeling flash can be fired to check the lighting effects (lighting balance, shadows,

etc.) before you take the picture. See page 50.

• Make sure the slave units are within the effective range of the master unit.
• After the picture is taken, the slave unit’s operation result is displayed on the LCD

panel.

• With the slave unit's main switch set to SE (Save Energy), the slave unit turns off

automatically if it is left unused for over 60 minutes*. While the slave unit is off due to
this SE mode, SE is displayed on the LCD panel. Within 1 hour** after the slave unit
turns off in the SE mode, the slave unit can be turned on again by pressing the master
unit's test firing button.

• If the manual flash mode has been set and you press the master unit’s pilot lamp, all

the slave units will fire a test flash simultaneously at the manually-set flash output.

• After pressing the shutter button halfway, test firing cannot be executed during the first

6 sec.

*

Custom Function CF-4 can change this to 10 minutes. See page 113.

** Custom Function CF-5 can change this to 8 hours. See page 113.

CF

05. F073-E (51~) 02.4.1 2:12 PM Page 59