Asus P5Q-EM DO - Manual (Page 50)

1-36 Chapter 1: Product introduction
ASUS Q-Connector (system panel)
You can use the ASUS Q-Connector to connect/disconnect chassis front panel cables in a
few steps. Refer to the following instructions to install the ASUS
Q-Connector.
1. Connect the front panel cables to the ASUS
Q-Connector.
Refer to the labels on the Q-Connector to
know the detailed pin definitions, and then
match them to the respective front panel
cable labels.
The labels on the front panel cables
may vary depending on chassis model.
2. Install the ASUS Q-Connector to the system
panel connector, making sure the orientation
matches the labels on the motherboard.
3. The front panel functions are now enabled.
The figure shows the
Q-Connector properly installed on the
motherboard.
P5Q-EM DO.indb 36 12/9/08 12:34:57 PM