Asus Maximus III Formula - Manual (Page 59)

2.8.2 Internal connectors
1. Intel ® P55 Serial ATA connectors (7-pin SATA 1-6)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives and optical disc drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5, and
1� configuration with the Intel ® Matrix Storage Technology through the onboard
Intel ® P55 chipset.
• These connectors are set to Standard IDE mode by default. In Standard
IDE mode, you can connect Serial ATA boot/data hard disk drives to these
connectors. If you intend to create a Serial ATA RAID set using these
connectors, set the Configure SATA as item in the BIOS to [RAID]. See
section �.4.5 Storage Configuration for details.
• Before creating a RAID set, refer to section 4.4 RAID configurations or the
manual bundled in the motherboard support DVD.
• You must install Windows ® XP Service Pack 2 or later versions before using
Serial ATA hard disk drives. The Serial ATA RAID feature is available only if
you are using Windows ® XP SP2 or later versions.
• When using hot-plug and NCQ, set the Configure SATA as in the BIOS to
[AHCI]. See section �.4.5 Storage Configuration for details.
ROG Maximus III Formula 2-31