Asus Maximus III Formula - Manual (Page 78)

3-4 Chapter 3: BIOS setup
3.1.2 ASUS EZ Flash 2 utility
The ASUS EZ Flash 2 feature allows you to update the BIOS without having to
use a DOS-based utility. The EZ Flash 2 utility is built in the BIOS chip so it is
accessible by pressing + during the Power-On Self Tests (POST).
Before you start using this utility, download the latest BIOS from the ASUS
website at www.asus.com.
To update the BIOS using EZ Flash 2
1. Insert the USB flash disk that contains the latest BIOS file to the USB port,
and then launch EZ Flash 2 in any of these two ways:
• Press + during POST to display the following.
• Enter the BIOS setup program. Go to the Tools menu to select EZ Flash
2 and press to enable it.
ASUSTek EZ Flash 2 BIOS ROM Utility V3.34
Current ROM Update ROM
A:
Note
[Enter] Select or Load [Tab] Switch [V] Drive Info
[Up/Down/Home/End] Move [B] Backup [Esc] Exit
FLASH TYPE: MXIC 25L1605A
PATH: A:\
BOARD: Maximus III Formula
VER: 0229
DATE: 07/29/2009
BOARD: Unknown
VER: Unknown
DATE: Unknown
2. Press to switch between drives until the correct BIOS file is
found. When found, EZ Flash 2 performs the BIOS update process and
automatically reboots the system when done.
• This function can support devices such as a USB flash disk with FAT 32�16
format and single partition only.
• DO NOT shut down or reset the system while updating the BIOS to prevent
system boot failure!
Ensure to load the BIOS default settings to ensure system compatibility and
stability. Select the Load Setup Defaults item under the Exit menu. See
section 3.9 Exit Menu for details.