Asus Maximus III Formula - Manual (Page 104)

3-30 Chapter 3: BIOS setup
�.6.6 APM Configuration
Restore On AC Power Loss [Power Off]
[Power Off] The system goes into off state after an AC power loss.
[Power On] The system goes into on state after an AC power loss.
[Last State] The system goes into either off or on state, whatever the system
state was before the AC power loss.
3.6.4 ACPI APIC Support [Enabled]
Allows you to enable or disable the Advanced Configuration and Power Interface
(ACPI) support in the Advanced Programmable Interrupt Controller (APIC).
[Disabled]
When set to [Disabled], the system disable the Advanced
Configuration and Power Interface (ACPI) support in the Advanced
Programmable Interrupt Controller (APIC).
[Enabled] When set to [Enabled], the ACPI APIC table pointer is included in
the RSDT pointer list.
3.6.5 EuP Ready [Disabled]
[Disabled] Disables the Energy Using Products (EuP) Ready function.
[Enabled] Allows BIOS to switch off some power at S5 state to get system
ready for the EuP requirement. When set to [Enabled], power for
WOL, WO_USB, audio and onboard LEDs will be switched off at
S5 state.
v02.61 (C)Copyright 1985-2009, American Megatrends, Inc.
BIOS SETUP UTILITY
Advanced
←→ Select Screen
↑↓ Select Item
+- Change Options
F1 General Help
F10 Save and Exit
ESC Exit
APM Configuration
Restore on AC Power Loss [Power Off]
Power On By RTC Alarm [Disabled]
Power On By PCI Devices [Disabled]
Power On By PCIE Devices [Disabled]
Power On By PS/2 Keyboard [Disabled] PS/2 Keyboard [Disabled]
to select
whether or not to
restart the system
after AC power loss.