Asus P8P67 WS Revolution - Manual (Page 43)

2.2.8 Internal connectors
1. Intel ® P67 Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_1/2 [gray])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial
ATA 6.0 Gb/s signal cables.
• These connectors are set to [AHCI Mode] by default. If you intend to create
a Serial ATA RAID set using these connectors, set the SATA Mode item in
the BIOS to [RAID Mode]. Refer to section
�.5.4 SATA Configuration for
details.
• Before creating a RAID set, refer to section 4.4 RAID configurations or the
manual bundled in the motherboard support DVD.
• When using hot-plug and NCQ, set the SATA Mode in the BIOS to [AHCI
Mode]. Refer to section
�.5.4 SATA Configuration for details.
• You must install Windows ® XP Service Pack 3 or later versions before using
Serial ATA hard disk drives. The Serial ATA RAID feature is available only if
you are using Windows
® XP SP3 or later versions.
ASUS P8P67 WS Revolution 2-17