Asus A7V266-E/AA - Manual (Page 83)

83
5. SOFTWARE SETUP
ASUS A7V266-E User’s Manual
5. S/W SETUP
5.4.1 Installing the Hard Disks
The RAID 0 setting allows users to reformat two hard disks with the same new OS
simultaneously. RAID 1 arrays can use a pre-existing hard disk along with a blank
hard disk, or two new hard disks.
1. Install the first and second hard disk into the hard disk bays of your system.
Connect each hard disk drive with a separate UltraDMA/100 cable, one to the
Primary ATA IDE1 connector, and the other to the Secondary ATA IDE2 connector
onboard the A7V266-E.
2. Connect the power cables to the hard disks.
3. Ensure that the ATA/100 / RAID 0/1 jumper 3 is reset from the default: [1-2] to
the RAID 0/1 setting: [2-3].
(See: Section 3.4.2, Hardware Setup: Motherboard Settings)
4. Boot-up the PC.
5.4.2 Enter FastTrak100 BIOS and FastBuild Utility
1. Boot-up your computer once more. If this is the first time you have booted
with two hard disks correctly installed, then FastTrak100™ “Lite” BIOS
scans the IDE drives and displays this screen:
2 . Press keys to display the FastBuild™ Utility Main Menu:
RAID
FastBuild (tm) Utility 1.31 (c) 1996-2000 Promise Technology, Inc.
Auto Setup . . . . . . . . . . [ 1 ] [ 1 ]
View Drive Assignments . . . . [ 2 ] [ 2 ]
View Array . . . . . . . . . . [ 3 ] [ 3 ]
Delete Array . . . . . . . . . [ 4 ] [ 4 ]
Rebuild Array. . . . . . . . . [ 5 ] [ 5 ]
Controller Configuration . . . [ 6 ] [ 6 ]
Press 1..6 to select Option [ESC] Exit
[ Main Menu ]
[ Keys Available ]