Asus A7V266-E/AA - Manual (Page 23)

ASUS A7V266-E User’s Manual 23
3. HARDWARE SETUP
3. H/W SETUP
Motherboard Settings
A7V266-E
0 1 0 1 0 1
A7V266-E USB Device Wake Up
USB45_PWR
USB23_PWR
USB01_PWR
+5V +5VSB
+5V
1 2
+5VSB
2 3
1 2 2 3
10) USB Device Wake-up (USB01_PWR/USB23_PWR/USB45_PWR)
Set these jumpers to +5V to allow wake up from the S1 sleep state (CPU stopped;
RAM refreshed; system running in low power mode) using the connected USB
devices. Set to +5VSB to allow wake up from S3 sleep state (no power to CPU;
RAM in slow refresh; power supply in reduced power mode). The default setting
for the three jumpers is 1-2 to select +5V (because not all computers have the
appropriate power supply).
NOTES:
1. This feature requires an ATX power supply that can supply at least 2A on
the +5VSB lead when these jumpers are set to +5VSB. Otherwise, the
system does not power up.
2. The total current consumed must NOT exceed the power supply capability
(+5VSB) whether under normal working conditions or in sleep mode.
11) IDE Channel Setting for ATA100 or RAID 0/1 (JP2601)
These jumpers enable the ATA100 IDE Controller, or the IDE RAID
controller function. The default setting enables ATA100.
Setting
JP2601
Enable ATA100 [1-2] (default)
Enable RAID 0/1 [2-3]
A7V266-E
0 1 0 1 0 1
A7V266-E ATA100/RAIDO Selection
RAID0/1 ATA100
JP2601
(Default)
1
2
3
2