Asus A7V266-E/AA - Manual (Page 66)

ASUS A7V266-E User’s Manual 66
4. BIOS SETUP
4. BIOS SETUP I/O Device Config
Onboard Peripheral Resource Control
Parallel Port Mode [ECP+EPP]
This field allows you to set the operation mode of the parallel port. [Normal]
allows normal-speed operation but in one direction only; [EPP] allows
bidirectional parallel port operation; [ECP] allows the parallel port to operate
in bidirectional DMA mode; [ECP+EPP] allows normal speed operation in
a two-way mode. Configuration options: [Normal] [EPP] [ECP] [ECP+EPP]
ECP DMA Select [3]
This field allows you to configure the parallel port DMA channel for the
selected ECP mode. This selection is available only if you select [ECP] or
[ECP+EPP] in Parallel Port Mode above. Configuration options: [1] [3]
[Disabled]
Onboard CIR I/O [Disabled]
This field allows you to select the I/O address and IRQ for consumer infrared
device. Configuration options: [Disabled] [2E0-2E8H] [3E0-3E8H]
Onboard AC97 Modem Controller [Auto]
Onboard AC97 Audio Controller [Auto]
[Auto] allows the BIOS to detect whether you are using any modem/audio
device. If a modem/audio device is detected, the onboard modem/audio
controller is enabled; if no modem/audio device is detected, the controller is
disabled. If there are conflicts with the onboard modem/audio controller, set
the appropriate field to [Disabled]. Configuration options: [Disabled] [Auto]