GE Industrial Solutions Power-Vac Metal Clad Switchgear; Section 3 - Manual (Page 13)

52
Fig – A(1)-3
View looking up into the front bottom compartment of a 2 High-A rollout stack
Step – 2, Remove vertical mid barrier in front lower compartment
Remove the vertical mid barrier located in the upper part of the lower front compartment.
This barrier is located approximately 49 inch from the front of the stack. See Fig – A(1)-
4a for identification of barrier in the breaker compartment and A(1)-4b for identification
of barrier in a PT/CPT rollout compartment
Step – 3, Remove vertical mid barrier in front upper compartment
Remove the vertical mid barrier located in the lower part of the upper front compartment.
This barrier is located approximately 49 inch from the front of the stack. See item # 3 of
This barrier can be
removed when the 3
taptites are removed.
Remove this
barrier
The underside of
the taptites
Remove this
barrier
Fig A(1)-4a
View looking into typical
front lower breaker
compartment
Fig A(1)-4b
View looking into typical
front lower PT/CPT rollout
compartment