GE Industrial Solutions Digital Energy USB_RS232_Relay Interface Card - Manual (Page 4)

2 - Introduction
2.1 Introduction
The USB/RS232/Relay interface card enables advanced communication between the UPS and the computer
(software required). The card is to be installed in the option slot of the Digital Energy™ VH Series UPS models.
The card is provided with an USB connector, a 9-pole sub-D connector and four potential free changeover
contacts, representing: mains failure, general alarm, battery low and bypass active.
The identification number of the USB/RS232/Relay Card is 18802.
2.2 Intended use
• The USB/RS232/Relay interface card is to be installed in the option slot of the Digital Energy™ VH Series
UPS models.
• The technical data can be found in this document and shall be strictly observed.
2.3 Warranty
GE Consumer & Industrial SA, operating through its authorized agents, warrants that the standard products
will be free of defects in materials and workmanship for a period of 36 months after the date of invoice, or
such other period as may be specified.
NOTE
This warranty does not cover failures of the product which result from incorrect installation,
misuse, alterations by persons other than authorized agents, or abnormal operating conditions.
3 - Installation
3.1 Package contents
The USB/RS232/Relay Card kit contains the following items:
-
ESD-proof bag with USB/RS232/Relay Card (PCB IM0131A1, article ID# 18802)
-
plastic bag with two screws
-
USB cable
-
RS232 cable
-
this manual
Inspect the card for damage after unpacking. If any damage is present please immediately notify the carrier
and place of purchase.
WARNING! In case of recognizable damage do not insert the card in the UPS
modifications reserved
OPM_CON_ACC_REL_VHX_XGB_V010
3 Installation manual USB/RS232/Relay card VH Series 1.0 (GB)