GE Industrial Solutions Remote Racking Operator: Low Voltage AKR Circuit Breakers - Manual (Page 12)

Remote Racking Operator for AKR Breakers
12
4-3 Field Modification to existing Breaker doors.
All existing small and large frame AKR Breaker
doors can be modified in the field to
accommodate the new AKR remote racking
operator. A drilling template kit (CAT#
AKREGDRTEMP) can be provided with (5) drilling
templates (one for each type of breaker door).
The racking flag assemblies (CAT#
AKREGDRMOD) can also be ordered for each
modified breaker door.
Below is a picture demonstrating how to locate
and drill holes in an existing 30S, 75/100 or 125
breaker door. A picture demonstrating how to
locate and drill the holes for a 30/50 breaker
door is located on the next page.
Refer to page 14 for remote racking flag details.
1. Insert bushing of template into
the existing racking hole.
2. Align inside edge of template
with outer edge of door.
3. Drill (1) 1.75” diameter
hole through the door.
4. Drill (1) 0.251”
diameter hole
through the door.
Figure 7
Door drilling template for AKR 30S, 75/100 and 125 doors
Existing breaker compartment door.