GE Industrial Solutions ASTAT XT User Manual
Astat xt
Table of contents
Document Outline
- 1. GENERALITIES
- 2. TYPES AND RATINGS
- 3. TECHNICAL SPECIFICATIONS
- 4. CONTROL KEYPAD
- 4.1 LCD Arrangement
- 4.2 Push-Buttons
- 4.3 Status LEDs
- 4.4 Reviewing and Modifying Parameters
- 4.5 Special Actions Performed in Test/Maintenance Mode
- 4.6 Mode Pages
- 4.7 Overview of All Mode Pages and Factory Defaults
- 4.7.1 Display Mode – Page 0
- 4.7.2 Main Settings – Page 1
- 4.7.3 Start Settings – Page 2
- 4.7.4 Stop Settings – Page 3
- 4.7.5 DUAL Settings Parameters – Page 4
- 4.7.6 Slow Speed & Energy Save Parameters – page 5
- 4.7.7 Fault Settings – Page 6
- 4.7.8 I/O Settings Parameters – Page 7
- 4.7.9 COMM. Parameters – Page 8 – With the Modbus standard PCB
- 4.7.10 Comm. Parameters42 – Page 8 – With the Profibus optional PCB
- 4.7.11 Comm. Parameters42 – Page 8 – With the DeviceNet Optional PCB
- 4.7.12 Statistical Data – page 9
- 4.8 Non Adjustable Protection and Fault Reset
- 4.9 Timing Occurrence Table
- 5. INSTALLATION
- 6. STARTING PROCEDURE
- 7. TROUBLE SHOOTING
- 8. APPLICATION DIAGRAMS
- 8.1 Terminal 21 Connections With Various Mains
- 8.2 Control Supply, Control Input and Mains are From the Same Source, Neutral Connected to Terminal 21
- 8.3 Control Supply and Control Input From the Same Source, Neutral not Connected to Terminal 21
- 8.4 Control Supply and Control Input from Separate Sources
- 8.5 Soft Start, Soft Stop and Stop, Control Supply and Control Input from the Same Source
- 8.6 Soft Start, Soft Stop and Stop, Control Supply and Control Input from Separate Sources
- 8.7 Soft Start and Immediate Stop (no Soft Stop)
- 8.8 Soft Start and Soft Stop
- 8.9 Soft Start, Soft Stop and Immediate Stop
- 8.10 Energy Save, Slow Speed or Reset
- 8.11 Slow Speed and Slow Speed Reverse
- 8.12 External Fault
- 8.13 Line Contactor
- 8.14 Bypass Contactor
- 8.15 Reversing with Two Line Contactors
- 8.16 Operating via Communication Links
- 8.17 D.Set: Generator Parameters Wiring
- 8.18 Short Circuit Protection
- 8.19 Transient Protection
- 8.20 Inside Delta Configuration
- 9. DIMENSIONS