GE Industrial Solutions ABB SACE Isomax S7 to Spectra RMS SK Frame - Manual

GEH-709 ABB S7 Replacement Accessory List
ABB SACE Isomax S7 to
Spectra
®
RMS SK Frame
A Spectra ® RMS molded-case circuit breaker,
designated by an SKT Interrupt tier, may be used to
replace an ABB SACE Isomax S7 equivalent within an
installed Spectra ® Series Panelboard.
Use the Table below to match an existing ABB SACE
Isomax S7 to its equivalent Spectra
® RMS molded-
case circuit breaker, based on trip function. If
applicable, neutral sensor assemblies are also listed
and should be replaced with the breaker.
The list of accessories shown below, are required to
properly install a new Spectra® RMS SK Frame into
the existing panel enclosure.
APP2W - 2X Filler Plate for 45W section (qty1 per
breaker)
AMCB3KMFP - SK mounting hardware including filler
plate, straps, and brackets (qty1 per breaker)
GTPXXXXUXX12 - Universal Rating Plugs for
microEntelliguard™
Trip Units (qty1 per breaker)
See GE Buylog or DEH-41318 for catalog details
ABB SACE
Isomax S7
Trip
Function
Spectra® RMS
SK
Interrupt Tier S7 Neutral
Sensor Assembly
(CAT#)
SK Neutral
Assembly
(CAT#)
S7H1000B0K LI 1 SKTC3408L3XX 2 65kA @ 480Vac n/a n/a
S7H1000C0K LSI SKTC3408L3XX 2 65kA @ 480Vac n/a n/a
S7H1000E0K LSIG SKTC3408L4XX 2 65kA @ 480Vac ANK100GFABB ANK800GF 3
S7H1200B0K LI 1 SKTC3412L3XX
65kA @ 480Vac n/a n/a
S7H1200C0K LSI SKTC3412L3XX
65kA @ 480Vac n/a n/a
S7H1200E0K LSIG SKTC3412L4XX
65kA @ 480Vac ANK120GFABB ANK120GF
1 GE replacements for LI breakers contain the LSI trip function (L3)
2 For 900-1000A applications, change 3408 to 3410 in center of catalog number
3 For 900-1000A applications, change 800 to 100 in the center of the Neutral catalog number
NOTE: Consult the GE Buylog Section 3 and Section 9 for lugs and other accessories not explicitly
mentioned in this document