Warning, Notice – GE Industrial Solutions GE TR5000 Series User Manual

Page 18

2020004403 (12/09) Page 18 of 18

SERVICING / TROUBLESHOOTING:

The GE TR5000 Series SPD contains no user serviceable parts and requires no calibration. The

rugged design of the SPD should provide many years of service.

Should a condition occur that results in premature failure of the GE TR5000 SPD, the integral

fusing or required circuit breaker will safely interrupt current flow through the SPD without

disrupting power to the protected equipment. This will remove the SPD from the power

system and the load equipment will remain unprotected from subsequent surge activity until

the SPD is replaced.

If a change in operational status/alarm indication occurs, a qualified (licensed) electrician should

inspect the electrical system to verify electrical system integrity. If the SPD remains in alarm

after system inspection/corrections have been made, the SPD should be replaced. For further

assistance, contact your local sales representative or call GE Power Quality at 1-800-637-1738.

NOTICE

These instructions do not purport to cover all details or variations in equipment nor to provide for

every possible contingency to be met in connection with installation, operation, or maintenance.

Should further information be desired or should particular problems arise which are not covered

sufficiently for the purchaser's purposes, the matter should be referred to the GE Company.

WARNING

IN THE EVENT OF AN SPD ALARM CONDITION, DO NOT ATTEMPT

TO DIS-ASSEMBLE THE SPD TO REPLACE FUSING OR OTHER

COMPONENTS. THE SPD CONTAINS FUSING COMPONENTS THAT

WILL ONLY OPEN WHEN THE SPD HAS FAILED IN A NON-

SERVICEABLE CONDITION. THE ENTIRE SPD MUST BE REPLACED.

CONTACT GE POWER QUALITY AT 1-800-637-1738

GE Digital Energy – Power Quality

830 W 40th Street, Chicago, IL 60609 USA

Information subject to change without notice.

Please verify all details with GE.