3 flow control – SENA LS110 User Manual
Page 42
42
-------------------------------------------------------------------------------
Serial port configuration
-------------------------------------------------------------------------------
1. Baud rate : 9600
2. Data bits : 8
3. Parity : None
4. Stop bit(s) : 1
5. Flow control : Hardware
6. Inter-character timeout : 0
7. Host mode : TCP Client
8. Destination IP : 192.168.23.30
9. Destination port : 7001
10. Inactivity timeout : 0
11. Cyclic connection : 0
12. DTR behavior : Always HIGH
13. DSR behavior : None
14. Allowed IP : 0.0.0.0
15. Allowed subnet : 0.0.0.0
---> 3
Select parity (1 = None, 2 = Odd, 3 = Even)
---> 1
Figure 4-11 Set up Parity
4.2.3 Flow Control
The factory default setting of flow control is None. Only hardware flow control using RTS/CTS is
supported by the LS110. Hardware flow control method controls data communication flow by sending
signals back and forth between two connected devices.
It can be configured using ‘Flow control’ menu.
-------------------------------------------------------------------------------
Serial port configuration
-------------------------------------------------------------------------------
1. Baud rate : 9600
2. Data bits : 8
3. Parity : None
4. Stop bit(s) : 1
5. Flow control : Hardware
6. Inter-character timeout : 0
7. Host mode : TCP Client
8. Destination IP : 192.168.23.30
9. Destination port : 7001
10. Inactivity timeout : 0
11. Cyclic connection : 0
12. DTR behavior : Always HIGH
13. DSR behavior : None
14. Allowed IP : 0.0.0.0
15. Allowed subnet : 0.0.0.0
---> 5
Select flow control (1 = None, 2 = Hardware)
--->
Figure 4-12 Set up the Flow control