SENA LS110 - Manual (Page 18)

18
3: IP Address Configuration
A valid IP address needs to be assigned before the LS110 starts to work in the user's network
environment. A network system administrator may provide the user with this IP address setting
information for the network. The IP address must be unique within the network. Otherwise, the LS110
will not have a valid connection .
Users can choose the desired IP mode , i.e., Static IP and DHCP. The factory default IP mode is
Static IP mode. Table 3-1 shows the parameter items for IP configuration.
Table 3-1 IP configuration parameters
IP address
Subnet mask Static IP
Default gateway
DHCP No parameters required
3.1 Static IP
3.1.1 Overview
In the Static IP mode, users have to manually specify all the network parameters such as IP
addresses of the LS110, valid subnet mask and the default gateway IP address.
3.1.2 Static IP Configuration
To configure IP configuration parameters of the LS110, use ‘IP mode’ menu. Basic usage of ‘IP mode’
is as follows.
-----------------------------------------------------------------------------
Welcome to LS110 Configuration Page
Serial No. :
MAC Address : 00:01:95:AF:BD:44
F/W REV. : v0.4.8
IP Mode : Static IP IP Address : 192.168.23.12
-----------------------------------------------------------------------------
Console#1 (Serial) : Connected
Console#2 (Telnet) : Available
Console#3 (Telnet) : Available
-----------------------------------------------------------------------------
1. IP configuration
2. Serial port configuration
3. System information
4. System administration
5. Save changes
6. Exit without reboot
7. Save and reboot