Dexter Laundry T-80 Reversing (On-Premise) User Manual
Page 5
5
INSTALLATION AND OPERATING INSTRUCTIONS
INDUSTRIAL DRYER
UNCRATING
1. Remove cardboard container and innerpack.
2. Complete the uncrating as described in the procedure listed on the instruction sheet taped to
the loading door glass.
DRYER INSTALLATION
1. CODE CONFORMITY. All commercial dryer installations must conform with local codes
or, in the absence of local codes, with the latest edition of the National Fuel Gas Code ANSI
Z223.1A Canadian installations must comply with current Standard CAN/CGA-B1 49(.1 or
.2) Installation Code for Gas Burning Appliances or Equipment, and local codes if
applicable. The appliance, when installed, must be electrically grounded in accordance with
the latest edition of the National Electrical Code, ANSI/NFPA70, or, when installed in
Canada, with Standard CSA C22.1 Canadian Electrical Code Part 1.
2. INSTALLATION CLEARANCES: This unit may be installed at the following alcove
clearances.
I
Left side 0" (*)
II Right side 0" (*)
III Back
18" [457] (Certified for 1" [25] clearance; however, 18" [457] clearance is
necessary behind the belt guard to allow for servicing and maintenance)
IV Front
48" [1219] to allow use of dryer.
V Top
Refer to figure labeled “Vertical Clearance Dimensions”.
AB.
Certification allows 0" clearance at the top 1" [25] back from the front.
However, a 2" [13] clearance is required to allow opening the upper
service door.
CD.
A 4" [102] clearance is required at the top between 1" [25] and 4"[102]
from the front.
E.
A 10" [254] clearance is required from the top at all other points.
VI. Floor
This unit may be installed upon a combustible floor.
(*) Units may be installed in direct contact with an adjacent dryer, providing allowance is
made for opening upper and lower service doors.
Do not obstruct the flow of combustion and ventilation air.
Maintain minimum of 1" [25] clearance between duct and combustible material.
Refer to installation label attached to the inside surface of the upper door of the dryer for other
installation information.