Dexter Laundry T-80 Reversing (On-Premise) - Manual (Page 17)

17
TEMPORARY REVERSING DRYER CONTROLLER
PROGRAMMING
The temporary programming mode will allow the change of the stored dry cycle settings in the
dryer controller for one complete dry cycle. After the dry cycle is complete, the default settings
that existed before the temporary change are restored. The temporary dry cycle can be stopped
and cleared at any time during the dry cycle operation.
To temporarily change a dryer controller cycle, follow the procedures below. Things that are
displayed on the 4-digit numeric display will be in “quotation marks”. Keys on the dryer
controller touch pad that physically need to be pressed will be in CAPITAL AND BOLD
LETTERS.
If, at any time, you want to escape the temporary programming mode while changing the
program settings, you can press the STOP key on the dryer controller touch pad if the 4-digit
numeric display is not flashing. The SELECT/ENTER key on the dryer controller touch pad
can be pressed and released to enter the flashing value shown on the 4-digit numeric display and
allow you to escape.
If you press and release the STOP key on the dryer controller touch pad, when the 4-digit
numeric display is not flashing, the temporary changes to the dry cycle program will be
cancelled. The stored dry cycle settings that existed before the temporary change will then be
restored.
If, at any time, you want to start the temporary dry cycle during the temporary programming
mode, press and release the START key on the dryer controller touch pad if the 4-digit numeric
display is not flashing. The SELECT/ENTER key on the dryer controller touch pad can be
pressed and released to enter the flashing value shown on the 4-digit numeric display and allow
you to start the temporary dry cycle. If you start the temporary dry cycle, the 4-digit numerical
display will change to the total dry time and count down to 0 as the dry cycle progresses.
___________________________________________________________________
PROCEDURE
1) Make sure the dryer is not in a dry cycle. The 4-digit numeric display on the dryer controller
will show “LOAd” when the dryer is not in a dry cycle.
2) Press and release the UP or DOWN arrow keys on the dryer controller touch pad to chose the
dry cycle that you want to change (dry cycle 1 through 5). The dry cycle L.E.D. will
illuminate to indicate which dry cycle you are choosing. If you press either arrow key and
hold it down, the controller will sequence through the five dry cycles.
3) Press and release the CYCLE key on the dryer controller touch pad once you have chosen
the dry cycle you want to change. After you press this key, the programming L.E.D. and the
dry time L.E.D. will illuminate. The dry cycle L.E.D. will remain illuminated. The total dry
time will also be displayed on the 4-digit numeric display.
4) Press and release the UP or DOWN arrow keys to change the total dry time. Once either of
the arrow keys is pressed, the dry time L.E.D. and the total dry time on the 4-digit numeric