Dexter Laundry T-80 Reversing (On-Premise) - Manual (Page 20)

20
controller display will show a flashing “185”. Each press of the UP arrow key will
increment the temperature by five degrees.
6) Now, press and release the SELECT/ENTER touch pad key on the dryer controller.
The number “185” will stop flashing and the temperature L.E.D. will switch off. The
dryer control display will now show a number “2”, the cool down L.E.D. will
illuminate, and the programming L.E.D. and dry cycle 5 L.E.D. will remain on.
7) Press and release the SELECT/ENTER key on the dryer controller touch pad, since
the desired cool down time is two minutes. After you press the SELECT/ENTER
touch pad key on the controller, the cool down L.E.D. will switch off. The dryer
controller display will show “nrEv”, the reversing L.E.D. will illuminate, and the
programming L.E.D. and dry cycle 5 L.E.D. remain on.
8) Press and release the UP or DOWN arrow key once. A flashing “rEv” will appear on
the dryer controller display and the reversing L.E.D. will start to flash. Each press
and release of either arrow key will toggle between the reversing mode (“rEv”) and
non-reversing mode (“nrEv”).
9) Press and release the SELECT/ENTER key. Once this key is pressed and released,
the programming L.E.D. and the reversing L.E.D. will switch off. The dry cycle 5
L.E.D. will remain on. The flashing “rEv” will stop flashing and remain on.
You are now ready to start the new dry cycle. This new dry cycle will be in effect for
one dry cycle only. After the dry cycle is done, or if the STOP touch pad key on the
dryer controller is pressed and released twice, consecutively, the cycle 5 program will
revert to the factory default settings.
If you press the START touch pad key on the dryer controller, the controller display
will change from “rEv” to the number “42” and dry cycle 5 will begin.
PERMANENT REVERSING DRYER CONTROLLER
PROGRAMMING
The permanent programming mode will allow the change of the stored dry cycle settings in the
dryer controller until the operator physically changes them again. The factory default settings
can be restored in the dryer controller by pressing the default settings pushbutton on the back
(component) side of the dryer controller circuit board. It is labeled and located at the lower
middle side of the printed circuit board, as you face the component side of the board. It must be
pressed and held down for at least three seconds.
To permanently change a dryer controller cycle, follow the procedure below. Things that are
displayed on the 4-digit numeric display will be in “quotation marks”. Keys on the touch pad
that physically need to be pressed will be in CAPITAL AND BOLD LETTERS.
If, at any time, you want to escape the permanent programming mode while changing the
settings, you can press and release the STOP key on the dryer controller touch pad if the 4-digit