Dexter Laundry T-80 Reversing (On-Premise) User Manual

Page 24

11. Press and release the UP or DOWN arrow key once. A flashing “rEv” will appear on the

dryer controller display and the reversing L.E.D. will start to flash. Each press and release of
either arrow key will toggle between the reversing mode (“rEv”) and non-reversing mode
(“nrEv”).

12. Press and release the SELECT/ENTER key. Once this key is pressed and released, the

reversing L.E.D. will switch off. The programming L.E.D. and the dry cycle 5 L.E.D. will
remain on. The flashing “rEv” will be replaced by the word “Prog”.

13. Press and release the STOP touch pad key. The dry cycle 5 L.E.D. will remain on and the

programming L.E.D. will switch off. The dryer controller display will change to the word
“LOAd”.

The dryer is now ready for the new modified dry cycle to start. This modified dry cycle 5
program will remain in the dryer controller memory until the default settings push button is
pressed. This default settings push button is located on the component side of the dryer
controller printed circuit board at the lower middle side.