Dexter Laundry T-80 Reversing (On-Premise) - Manual (Page 19)

19
programming L.E.D. will switch off. The reversing L.E.D. and the dry cycle L.E.D. will
remain on. The flashing reversing (rEv) or the non-reversing (nrEv) on the 4-digit numeric
display will stop flashing and remain.
12) At this point, you have two choices. 1) You can perform the modified dry cycle by pressing
and releasing the START key on the dryer controller touch pad, or 2) You can clear the
modified dry cycle program by pressing and releasing the STOP key once. If you start the
modified cycle, the total dry time will appear on the 4-digit numeric display and it will count
down to 0 as the dry cycle progresses. If you choose to clear the modified dry cycle, the 4-
digit numeric display will change to “LOAd”.
TEMPORARY DRYER CONTROLLER PROGRAMMING
EXAMPLE
REQUIREMENTS: Dry a load, in reverse mode, with 40 minutes of actual heat at 185
0
F and
two minutes of cool down.
The following procedure will show you how to temporarily modify the existing dry cycle 5
program for one cycle of drying. It is based on the assumption that the factory defaults have not
been permanently changed. If they have been changed, the steps of this procedure will be the
same, but the values that are displayed will be different. The amount of times that the dryer
controller touch pad UP or DOWN keys must be pressed and released may also be different.
If you want the change to be permanent, go to the “PERMANENT REVERSING DRYER
CONTROLLER PROGRAMMING” section of this manual.
PROCEDURE
1) After the load has been placed in the dryer, press and release the UP or DOWN touch
pad key on the dryer controller until the L.E.D. for dry cycle 5 is illuminated.
2) Press and release the CYCLE key on the dryer controller touch pad. You will see the
number “25” on the dryer controller display. The programming L.E.D. and dry time
L.E.D. will be illuminated.
3) Press and release the UP arrow key on the dryer controller touch pad 17 times so the
display will show a flashing “42”. When the UP arrow touch pad key is pressed the
first time, the number “26” will be flashing on the dryer controller display. Each
number after that will also flash.
4) Now, press and release the SELECT/ENTER touch pad key on the dryer controller.
The number “45” will stop flashing and the dry time L.E.D. will switch off. The
dryer controller display will now show “175”, the temperature L.E.D. will illuminate,
and the programming L.E.D. and dry cycle 5 L.E.D. will remain on.
5) Press and release the UP arrow key on the dryer controller touch pad two times so the