StreetGlow OPTX Neon Undercar Kit - Manual (Page 2)

Locate a desired location for tube placement that is away from all fuel lines, exhaust
system, areas of extreme heat, ABS components, moving parts and where lifts or jacks are
used to raise your vehicle (see Dia. 1). With nylon clamps, fasten tubes to your vehicle with
the tube clamp screws provided. Tubes are marked for proper clamp placement (4 clamps
per 48” tube, 3 clamps per 30” tube).
On a flat moisture free area, mount multi-outlet power distribution block that is near your
power source (ie: fuse box or battery) and accessible for neon wire lead connections, but
away from engine and moving parts.
Run neon power wires to the distribution block that allows for the least length of wire. Avoid
slack, trim off surplus wire from neon tubes before connecting to distribution block.
Complete connection of all neon power wires (see Dia. 2). Secure with the provided wire
clamps (allow 2” of straight wire from neon tube before making a bend). In the event where
neon power wires need to be lengthened, make sure to insulate connection with black
electrical tape to ensure a moisture free connection (wire type: 18GA 12 volt).
Refer to wiring diagram for power and switch connections.
Installation is complete, enjoy!!
1)
2)
3)
4)
5)
OPTX UNDERCAR KIT INSTALLATION INSTRUCTIONS
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING NEON
* This product was designed for show use only. Laws vary from state to state so check your local laws regarding use of this
product while traveling on public roadways. The manufacturer assumes no responsibility for damages, fines or claims resulting from the
use of this product. The product was designed for show use only. Design and specifications are subject to change without notice.
All OPTX by StreetGlow products are covered by a comprehensive warranty.
OPTX by StreetGlow products are warranted against defective materials and workmanship for one year from date of purchase. Any product
that should fail for either defective materials or workmanship will be repaired or replaced, at StreetGlow’s option, as the sole remedy of the
buyer. Proof of purchase is required. All warranty claims are to be handled by selling agents. Accident, abuse, neglect, modifications,
broken glass, labor, transportation, improper installation and the use of products other than for their intended purposes are not covered.
NEITHER SELLER NOR THE MANUFACTURER SHALL BE LIABLE FOR ANY INJURY, LOSS OR DAMAGE, DIRECT,
INCIDENTAL OR CONSEQUENTIAL (INCLUDING, BUT NOT LIMITED TO INCIDENTAL OR CONSEQUENTIAL DAMAGES
FOR LOST PROFITS, LOST SALES, INJURY TO PERSON OR PROPERTY OR ANY OTHER INCIDENTAL OR CONSEQUENTIAL
LOSS), ARISING OUT OF THE USE OR THE INABILITY TO USE THE PRODUCT AND THE USER AGREES THAT NO OTHER
REMEDY SHALL BE AVAILABLE TO IT. Before using, the user shall determine the suitability of the product for the intended use, and
user assumes all risk and liability whatsoever in connection therewith. Some states and countries do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal
rights and you may also have other rights, which vary from state to state and from country to country.
DISCLAIMER: THE FOREGOING WARRANTY IS AN EXCLUSIVE WARRANTY IN LIEU OF ANY OTHER EXPRESS
WARRANTIES. ANY IMPLIED WARRANTIES (INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE) TO THE EXTENT THAT IT COULD APPLY TO ANY OF
THE PRODUCTS MANUFACTURED BY THE COMPANY SHALL BE LIMITED IN DURATION TO THE PERIODS OF THE
EXPRESS WARRANTY GIVEN ABOVE.
CONSEILS TECHNIQUES:
CONSEIL: 1) Les kits de châssis OPTX peuvent également être installés pour diverses
applications telles que les traverses de camion, les compartiments moteur, l'intérieur, etc.
Partout où vous voulez une lumière de néon de 48 ou 30 pouces.
CONSEIL: 2) Ajoutez notre module d'interface musicale pour créer une multitude d'effets.
CIRCUIT DE CÂBLAGE
TOOLS NEEDED
- Screw Gun w/
Phillips Head Bit
- Wire Strippers
- Electrical Tape
1- 16GA Power Harness
1- 18GA Power Wire (20’)
14- 3/4” Tube Clamps
14- 5/8” Tube Clamp Screws
12- 3/16” Wire Clamps
12- 5/8” Wire Clamp Screws
CONTENTS
2-
48” Neon Tubes (OPL48*)
2- 30” Neon Tubes (OPM30*)
1- Distribution Block
(5 amp. Max)
1- 3/4” Rocker Switch
2- Scotch Locks
*Add color code