StreetGlow LED Headlight Accents - Manual

All StreetGlow products are covered by a
comprehensive warranty.
StreetGlow neon products are warranted against defective
materials and workmanship for as long as the original purchaser
owns the product. StreetGlow Radio Bars and other non-neon
products (excluding fog lights and driving lights, and Xenon
white bulbs) are warranted against defective materials and
workmanship for two years from date of purchase. Fog lights
and driving lights, and Xenon white bulbs are warranted for
one year from date of purchase. Any product that should fail
for either defective materials or workmanship will be repaired
or replaced, at StreetGlow’s option, as the sole remedy of the
buyer. Proof of purchase is required. All warranty claims are to
be handled by selling agents. Accident, abuse, neglect,
modifications, broken glass (with the exception of SG201
Undercar Kit), labor, transportation, improper installation and
the use of products other than for their intended purposes are
not covered. NEITHER SELLER NOR THE MANUFACTURER
SHALL BE LIABLE FOR ANY INJURY, LOSS OR DAMAGE,
DIRECT, INCIDENTAL OR CONSEQUENTIAL (INCLUDING,
BUT NOT LIMITED TO INCIDENTAL OR CONSEQUENTIAL
DAMAGES FOR LOST PROFITS, LOST SALES, INJURY
TO PERSON OR PROPERTY OR ANY OTHER INCIDENTAL
OR CONSEQUENTIAL LOSS), ARISING OUT OF THE
USE OR THE INABILITY TO USE THE PRODUCT AND
THE USER AGREES THAT NO OTHER REMEDY SHALL
BE AVAILABLE TO IT. Before using, the user shall determine
the suitability of the product for the intended use, and user
assumes all risk and liability whatsoever in connection
therewith. Some states and countries do not allow the exclusion
or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you.
This warranty gives you specific legal rights and you may also
have other rights, which vary from state to state and from
country to country. DISCLAIMER: THE FOREGOING
WARRANTY IS AN EXCLUSIVE WARRANTY IN LIEU
OF ANY OTHER EXPRESS WARRANTIES. ANY
IMPLIED WARRANTIES (INCLUDING, BUT NOT LIMITED
TO ANY IMPLIED WARRANTY OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE) TO THE
EXTENT THAT IT COULD APPLY TO ANY OF THE
PRODUCTS MANUFACTURED BY THE COMPANY
SHALL BE LIMITED IN DURATION TO THE PERIODS OF
THE EXPRESS WARRANTY GIVEN ABOVE.
Design and specifications are subject to change without notice.
WARNING!
The retailer shall not be held responsible
for any damages that occur as a result
of defective products. StreetGlow products
are recommended for show and off-road
use only. Laws concerning the use of
aftermarket lighting products may vary
from state to state. For more information,
check with your local authority.
CONTENTS:
1 – Headlight LED System
INSTRUCTIONS:
1) Mount LED Power Pack close to
headlight housing using the double
sided tape provided.
*Clean mounting surface free of
dirt and oil deposits before mounting
2) When installing Headlight LED’s,
removal of the headlamp housing is
recommended for easy installation.
Locate the desired LED placement
in the headlamp housing and drill a
1/4” hole.
3) Run LED wires to each headlamp
housing and insert LED into 1/4”
mounting hole until flush (see
Mounting Diagram).
4) Power Connections
• Yellow Wire = Constant 12v
• Black Wire = Ground
• Blue Wire = Negative (Alarm Status)
• Orange Wire = 12v (Cruzin’ Mode)
5) Enjoy!
HEADLIGHT LEDs
1/4” hole
mounting
surface
ANHLED Power Pack
Power
(+/-)
LED
(+)
Alarm
(-)
4’
9’