StreetGlow Headlight Strobes - Manual

All StreetGlow products are covered by a comprehensive warranty.
StreetGlow neon products are warranted against defective materials and
workmanship for as long as the original purchaser owns the product.
StreetGlow Radio Bars and other non-neon products (excluding fog
lights and driving lights, and Xenon white bulbs) are warranted against
defective materials and workmanship for two years from date of purchase.
Fog lights and driving lights, and Xenon white bulbs are warranted for
one year from date of purchase. Any product that should fail for either
defective materials or workmanship will be repaired or replaced, at
StreetGlow’s option, as the sole remedy of the buyer. Proof of purchase
is required. All warranty claims are to be handled by selling agents.
Accident, abuse, neglect, modifications, broken glass (with the exception
of SG201 Undercar Kit), labor, transportation, improper installation and
the use of products other than for their intended purposes are not covered.
NEITHER SELLER NOR THE MANUFACTURER SHALL BE
LIABLE FOR ANY INJURY, LOSS OR DAMAGE, DIRECT,
INCIDENTAL OR CONSEQUENTIAL (INCLUDING, BUT NOT
LIMITED TO INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR
LOST PROFITS, LOST SALES, INJURY TO PERSON OR PROPERTY
OR ANY OTHER INCIDENTAL OR CONSEQUENTIAL LOSS),
ARISING OUT OF THE USE OR THE INABILITY TO USE THE
PRODUCT AND THE USER AGREES THAT NO OTHER REMEDY
SHALL BE AVAILABLE TO IT. Before using, the user shall determine
the suitability of the product for the intended use, and user assumes all
risk and liability whatsoever in connection therewith. Some states and
countries do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitations or exclusions may not apply to you.
This warranty gives you specific legal rights and you may also have
other rights, which vary from state to state and from country to country.
DISCLAIMER: THE FOREGOING WARRANTY IS AN EXCLUSIVE
WARRANTY IN LIEU OF ANY OTHER EXPRESS WARRANTIES.
ANY IMPLIED WARRANTIES (INCLUDING, BUT NOT LIMITED
TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE) TO THE EXTENT THAT
IT COULD APPLY TO ANY OF THE PRODUCTS MANUFACTURED
BY THE COMPANY SHALL BE LIMITED IN DURATION TO THE
PERIODS OF THE EXPRESS WARRANTY GIVEN ABOVE.
WARRANTY
I N F O R M A T I O N
STROBE CONTROL MODULE
FRONT
BACK
CONTENTS:
1- Digital Strobe Controller
3- 8’ strobe interface cables
2- 12’ strobe interface cables
Installation Hardware with Instructions
INSTRUCTIONS:
1) Using the installation hardware provided, mount the Digital
Strobe Controller in the desired location.
2) Run control wires to the corresponding strobe locations,
longer lengths (12’) run to the rear of the vehicle, the
shorter lengths (8’) run to the front or the side of the
vehicle. Run wires away from any moving parts (i.e. gearshift,
steering wheel, etc.).
3) Connect the 5 control wires to the corresponding controller
outputs (see Systemization Diagram).
4) Connect the strobe control wires to the strobe device’s
(ANSLV2, ANHLSV2) input.
5) Connect BLACK/WHITE strip wire to positive (+) 12v and
connect BLACK wire to negative (-) ground.
6) Enjoy!
CENTER OUT
1 2 3 4 5
OUT CENTER
1 2 3 4 5
LEFT TO RIGHT
1 2 3 4 5
NIGHT CRUZIN'
1 2 3 4 5
INCH WORM
1
1
2 3 4 5
2 3 4 5
RIGHT TO LEFT
1 2 3 4 5
1
2
3
4
5
ANSC5 ANSC5
ANSLV2
ANSLV2
ANSLV2
ANHLSV2
ANHLSV2
ANHLSV2
EXAMPLE 1 EXAMPLE 2
EXAMPLE 3 EXAMPLE 4
1
2
3
4
5
1
2
4
5
1
2
3
4
5
1
2
3
4
5
SYSTEMIZATION DIAGRAM
OVERVIEW OF PATTERNS
FRONT
BACK
Suggested
Strobe Placement
ANSC5 Strobe Controller is able to control up to 5 different
devices simultaneously. The controllable strobe components
are listed below:
ANSLV2 – Xenon Strobe Light
ANHLSV2 – Xenon Headlight Strobes
When using any combination of these newly designed products,
the user is able to create up to 9 different light patterns
(see Systemization Diagram for details).
PATTERN MODES:
Center Out Right to Left All Flash
Out Center Night Cruzin’ Random
Left to Right Inch Worm Demo
STROBE CONTROL MODULE
ANSC5 ANSC5