StreetGlow LED Washer Knozzles - Manual

All StreetGlow products are covered by a
comprehensive warranty.
StreetGlow neon products are warranted against defective
materials and workmanship for as long as the original purchaser
owns the product. StreetGlow Radio Bars and other non-neon
products (excluding fog lights and driving lights, and Xenon
white bulbs) are warranted against defective materials and
workmanship for two years from date of purchase. Fog lights
and driving lights, and Xenon white bulbs are warranted for
one year from date of purchase. Any product that should fail
for either defective materials or workmanship will be repaired
or replaced, at StreetGlow’s option, as the sole remedy of the
buyer. Proof of purchase is required. All warranty claims are to
be handled by selling agents. Accident, abuse, neglect,
modifications, broken glass (with the exception of SG201
Undercar Kit), labor, transportation, improper installation and
the use of products other than for their intended purposes are
not covered. NEITHER SELLER NOR THE MANUFACTURER
SHALL BE LIABLE FOR ANY INJURY, LOSS OR DAMAGE,
DIRECT, INCIDENTAL OR CONSEQUENTIAL (INCLUDING,
BUT NOT LIMITED TO INCIDENTAL OR CONSEQUENTIAL
DAMAGES FOR LOST PROFITS, LOST SALES, INJURY
TO PERSON OR PROPERTY OR ANY OTHER INCIDENTAL
OR CONSEQUENTIAL LOSS), ARISING OUT OF THE
USE OR THE INABILITY TO USE THE PRODUCT AND
THE USER AGREES THAT NO OTHER REMEDY SHALL
BE AVAILABLE TO IT. Before using, the user shall determine
the suitability of the product for the intended use, and user
assumes all risk and liability whatsoever in connection
therewith. Some states and countries do not allow the exclusion
or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you.
This warranty gives you specific legal rights and you may also
have other rights, which vary from state to state and from
country to country. DISCLAIMER: THE FOREGOING
WARRANTY IS AN EXCLUSIVE WARRANTY IN LIEU OF
ANY OTHER EXPRESS WARRANTIES. ANY IMPLIED
WARRANTIES (INCLUDING, BUT NOT LIMITED TO ANY
IMPLIED WARRANTY OF MERCHANTABILITY OR FIT-
NESS FOR A PARTICULAR PURPOSE) TO THE EXTENT
THAT IT COULD APPLY TO ANY OF THE PRODUCTS
MANUFACTURED BY THE COMPANY SHALL BE LIMIT-
ED IN DURATION TO THE PERIODS OF THE EXPRESS
WARRANTY GIVEN ABOVE.
Design and specifications are subject to change without notice.
WARNING!
The retailer shall not be held responsible
for any damages that occur as a result
of defective products. StreetGlow products
are recommended for show and off-road
use only. Laws concerning the use of
aftermarket lighting products may vary
from state to state. For more information,
check with your local authority.
LED WINDSHIELD WASHER NOZZLES
Mounting Surface
LED Rubber Gasket
Flat Pad
Lock Washer
Nut
Hose Nipple
Red = Fused
+12v
Black = Ground
CONTENTS:
2- LED Windshield Washer Nozzle
All necessary mounting hardware
INSTRUCTIONS:
1) Remove the original washer nozzles.
2) Install rubber gasket on new
washer nozzle.
3) Insert LED washer nozzle into
existing hole.
4) Connect RED wire to (+) 12v.
Connect BLACK wire to vehicle’s
chassis ground (-).
5) Plug windshield washer hose
onto nipple.
6) Enjoy!