StreetGlow LED Bolts - Manual

All StreetGlow products are covered by a
comprehensive warranty.
StreetGlow neon products are warranted against defective materials and
workmanship for as long as the original purchaser owns the product.
StreetGlow Radio Bars and other non-neon products (excluding fog lights and
driving lights, and Xenon white bulbs) are warranted against defective
materials and workmanship for two years from date of purchase. Fog lights
and driving lights, and Xenon white bulbs are warranted for one year from
date of purchase. Any product that should fail for either defective materials or
workmanship will be repaired or replaced, at StreetGlow’s option, as the sole
remedy of the buyer. Proof of purchase is required. All warranty claims are to
be handled by selling agents. Accident, abuse, neglect, modifications, broken
glass (with the exception of SG201 Undercar Kit), labor, transportation,
improper installation and the use of products other than for their intended
purposes are not covered.
NEITHER SELLER NOR THE MANUFACTURER SHALL BE LIABLE
FOR ANY INJURY, LOSS OR DAMAGE, DIRECT, INCIDENTAL OR
CONSEQUENTIAL (INCLUDING, BUT NOT LIMITED TO INCIDENTAL
OR CONSEQUENTIAL DAMAGES FOR LOST PROFITS, LOST SALES,
INJURY TO PERSON OR PROPERTY OR ANY OTHER INCIDENTAL
OR CONSEQUENTIAL LOSS), ARISING OUT OF THE USE OR THE
INABILITY TO USE THE PRODUCT AND THE USER AGREES THAT
NO OTHER REMEDY SHALL BE AVAILABLE TO IT.
Before using, the user shall determine the suitability of the product for the intended
use, and user assumes all risk and liability whatsoever in connection therewith.
Some states and countries do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitations or exclusions may not
apply to you. This warranty gives you specific legal rights and you may also
have other rights, which vary from state to state and from country to country.
DISCLAIMER: THE FOREGOING WARRANTY IS AN EXCLUSIVE
WARRANTY IN LIEU OF ANY OTHER EXPRESS WARRANTIES. ANY
IMPLIED WARRANTIES (INCLUDING, BUT NOT LIMITED TO ANY
IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE) TO THE EXTENT THAT IT COULD APPLY
TO ANY OF THE PRODUCTS MANUFACTURED BY THE COMPANY
SHALL BE LIMITED IN DURATION TO THE PERIODS OF THE
EXPRESS WARRANTY GIVEN ABOVE.
Design and specifications are subject to change without notice.
L.E.D. Light Bolts
CONTENTS:
2- L.E.D. Light Bolts
INSTRUCTIONS:
1. Drill a 1/4” hole in desired location.
2. Remove backing nut and install L.E.D. housing in the 1/4” hole.
3. Tighten backing nut.
4. Connect the STRIPED wire to a 12v (+) power source.
5. Connect the BLACK wire to the vehicle’s chassis ground.
6. Enjoy!
WARNING!
The retailer shall not be held responsible for any damages that occur as
a result of defective products. StreetGlow products are recommended
for show and off-road use only. Laws concerning the use of aftermarket
lighting products may vary from state to state. For more information,
please check with your local authority.
BLACK = ground
mounting surface
LED
backing nut
STRIPED = 12v (+)