dbx DriveRack 260 - Manual (Page 63)

DriveRack
®
55 DriveRack® User Manual
1.
3.
5.
4.
2.
ZC-1 & ZC-2
1. Select the ‘Panel’ number (this must match
the Dip Switch setting (ID#) set on the ZC
wall panel).
2. Select a ZC-1 (or ZC-2 if using a ZC-2) as
the ‘Type’.
3. Set the maximum amount of ‘Boost’ that will
be applied (0 dB typical).
4. Set the maximum amount of ‘Cut’ that will
be applied (40 dB typical).
5. Select which ‘Output(s)’ you would like this
ZC to control.
1.
3. 2.
ZC-3
1. Select the ‘Panel’ number (this must match
the Dip Switch setting (ID#) set on the ZC
wall panel).
2. Select a ZC-3 as the ‘Type’.
3. Select which ‘Program’ will be loaded when
selecting each corresponding position (A-D)
on the ZC wall panel.
1.
3.
4.
2.
ZC-4
1. Select the ‘Panel’ number (this must match
the Dip Switch setting (ID#) set on the
ZC-4).
2. Select a ZC-4 as the ‘Type’.
3. Select which ‘Switch Combination’ (binary #)
you would like to program.
4. After the correct Switch Combination
number is selected, select which
‘Program’ will be loaded when this Switch
Combination is triggered from the custom
switches, which are connected to the ZC-4.
Repeat steps 3 and 4 for all remaining Switch Combinations.
SECTION 6
Remote Control