Derale Performance Premium Engine Spin On Adapter with -10AN O-ring Ports, 20x1.5mm Engine Thread - Manual

35703-35704-35706-35724-InstructionSheet
INSTALLATION INSTRUCTIONS
ENGINE SPIN-ON ADAPTER KIT
PART # 35703, 35704, 35706 & 35724
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
Please read these instructions completely before beginning installation
INSTALLATION
VEHICLE TESTING
1. Remove the factory oil filter and clean the oil filter landing
surface on the engine block.
2. Take the Hex Sleeve Nut and slide it into the Spin-on Adapters
hex feature. Sleeve Nut will only install correctly in one direction.
(See Diagram #1)
3. Take the supplied Snap Ring and carefully install into the snap
ring groove of the casting making sure it is securely fastened.
(See Diagram #1)
4. Apply a light coat of oil onto the O-ring.
5. Take the O-ring and install into the groove on the Spin-On
Adapter.
6. Install onto the engine. (See Diagram #2)
7. Hand Tighten with the same force used in tightening a factory
oil filter.
When routing hoses, be sure to keep all hoses away from
sharp edges, moving parts and hot engine components.
Hoses should be routed carefully and should not be bent
in less than a 5” radius.
A kinked hose will restrict flow and could cause engine
failure.
1. Start the engine and quickly check all connections for leaks.
2. Turn-off the engine and check the oil.
3. Add oil as needed.
Warning:
Important:
Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on
vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the
parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting
the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.
Failure to follow instructions can lead to severe damage and personal injury.
TOOLS NEEDED
Open End Wrenches
Oil Filter Wrench
KIT CONTENTS
QTY. DESCRIPTION
1 Spin-On Adapter
1 O-ring
1 Hex Sleeve Nut
1 Snap Ring
PART # THREAD SIZE
35703
35704
35706
35724 3/4”-16
18mm x 1.5
20
22
mm x 1.5
mm x 1.5
The purpose of a Spin-on Adapter is to provide external
oil lines for remote filter mounts and oil coolers.
Diagram #1
Snap
Ring
Hex Sleeve
Nut
Snap Ring
Groove
Diagram #2
Rev.-072011
Spin-On
Adapter
Spin-On
Adapter
O-ring
7/8-14”
O-ring Ports