Derale Performance GM Thermostatic Sandwich Adapter with 1_2" NPT Ports - Manual

Diagram #2
Actual Sandwich
Adapter Not Shown
25720-InstructionSheet
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
INSTALLATION INSTRUCTIONS
ENGINE SANDWICH ADAPTER KIT
PART # 25720
Please read these instructions completely
before beginning installation
KIT CONTENTS
QTY. DESCRIPTION
1 Sandwich Adapter
1 O-ring
1 13/16-16 Sleeve Nut
IMPORTANT
In most cases the Factory Oil Filter will work with the supplied sandwich adapter. In some
applications where the frame or exhaust system interferes with the new filter depth we
recommend using a shorter filter length. See the chart below for possible filter options.
SLEEVE NUT
Diagram #1
SANDWICH ADAPTER INSTALLATION
ROUTING HOSES (HOSE & BARB FITTINGS SOLD SEPARATELY)
The Sandwich Adapter fits between the oil filter and the engine block.
Before removing the oil filter, check the clearance between the bottom of
the filter and the closest vehicle obstruction. If there are none, then proceed
with the installation. Otherwise, the Sandwich Adapter is 2-1/4” Thick, so
you will need 2-1/2” more clearance then stock. If you determine that the
stock filter will not fit, refer to the Filter Chart for alternative filter heights.
1. Remove the factory oil filter from the vehicle.
2. Take the O-ring provided, apply a thin film of oil and install into the
O-ring groove on the Sandwich Adapter. (See Diagram #2)
3. Making sure the engine block filter landing is clean from oil and dirt, take
the Sleeve Nut, Sandwich Adapter, O-ring, and install onto engine
sliding the Sleeve Nut thru the Sandwich Adapter. Turn sleeve nut
clockwise onto the engines filter nipple (Not Included). (See Diagram #2)
4. Using a torque wrench, torque the Sleeve Nut to 20 ft. lbs.
1. Using Teflon Tape or a suitable sealant, screw the Hose Barb Fittings
(Not Included) clockwise into the Sandwich Adapter until snug.
(See Diagram #2)
2. Using a wrench tighten the two Hose Barb Fittings.
3. Install both ends of the hose onto the Hose Barb Fittings using hose clamps (Not Included), forming a loop.
4. Take the looped end and route the hose to the oil cooler making sure to stay clear of sharp objects, exhaust systems, etc.
All bends in hose need to have a minimum radius of 5” or the diameter of a small coffee can.
5. Cut and attach hoses to the oil cooler. Secure hoses using zip ties.
1. Before starting the vehicle, check engine oil level and add accordingly.
2. Always check fluid levels on a flat surface.
3. After installation and vehicle has completely warmed up, recheck fluid level and inspect all connections for leaks.
Note:
SYSTEM CHECK
Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on
vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the
parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting
the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.
Failure to follow instructions can lead to severe damage and personal injury.
FRAM WIX FRAM WIX
THREAD FILTER FRAM FILTER WIX FILTER FRAM FILTER WIX
SIZE HEIGHT P/N HEIGHT P/N HEIGHT P/N HEIGHT P/N
5.25 PH13 5.17 51060 4.06 PH30 4.33 51069 13/16-16
(Included)
(Included)
(Included)