Derale Performance Single Side Ports 3__8" NPT Filter Mount with 3__4-16 Filter Threads" - Manual

INSTALLATION INSTRUCTIONS
REMOTE FILTER MOUNT MOUNT
PART # 13049
Please read these instructions completely before beginning installation
FILTER MOUNT INSTALLATION
VEHICLE TESTING
1. Choose a convenient location for the Side Ports Filter Mount.
Make sure there is enough space for future servicing of the
oil filter. Suggested Locations: Firewall, Radiator Support,
Fender well.
2. Take the Filter Nipple supplied, making sure the shorter end
of threads is installed onto the Side Ports Filter Mount.
(See Diagram #1)
3. Using the filter mount as a template, mark and drill three
3/16” holes.
3. Using #14 Sheet Metal Screws, install the
Side Ports Filter Mount onto the vehicle.
4. Using Teflon Tape or a suitable sealant install one Hose
Barb Fitting to a “IN” port and one to a “OUT” port. (Ports
are marked by the arrows.) Next install the 3/8” NPT Plugs
into the two remaining ports.
Do not over torque
Fittings.
5. Carefully route hose over to the Side Ports Filter Mount. Be
sure to connect In/Out Hose to the correct Port. Use Filter
mount arrows for flow direction.
Keep hoses away from sharp edges, moving parts
and exhaust. Do not bend hose sharper than a 5” radius.
6. Apply a light coat of oil onto the o-ring of your new oil filter
and install on the filter mount.
Warning:
Note:
1. Start the engine and quickly check all connections for leaks.
2. Turn-off the engine and check the oil.
3. Add oil as needed.
TOOLS NEEDED
7/8” Open End Wrench
Standard Screw Driver
1/8” Allen Wrench
Drill
3/16” Drill Bit
Teflon Tape
KIT CONTENTS
QTY. DESCRIPTION
1 Side Ports Filter Mount
1 Filter Nipple
2 3/8” Male NPT x 1/2” Hose Barb Fittings
2 3/8” NPT Plugs
3 #14 Sheet Screws
Diagram #1
IMPORTANT
This Filter Mount is machined with
3/8” NPT Ports and requires Teflon
Tape or a suitable sealant. Be sure
not to over tighten Fittings.
13049-InstructionSheet
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on
vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the
parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting
the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.
Failure to follow instructions can lead to severe damage and personal injury.
Oil Filter
(Not Included)
Filter
Nipple
Side Ports
Filter Mount
Revised-7/2/2012
Fittings
Plugs