GE P&W Pleated Filters - XPleat GF-T - Manual

Fact Sheet
Find a contact near you by visiting www.ge.com/water and clicking on “Contact Us” .
* Trademark of General Electric Company; may be registered in one or more countries.
©2009, General Electric Company. All rights reserved.
FspwXPleatGF-T_EN Nov-09
XPleat* GF-T Filters
Glass Microfiber Nominal and Absolute
Figure 1: XPleat GF-T Filters
Typical Applications
• For general water services
• For fine process fluid filtration
• For processes that require excellent flow rates
General Properties
XPleat GF-T filters are available in nominal and ab-
solute micron ratings (Figure 1). The nominal micron
ratings are: 0.2, 0.45, 1.0, 3.0 and 10.0 µm. The
absolute micron ratings are 1.0, 2.0, 4.0, 8.0 and
15.0 µm. Tables 1, 2, 3 and 4 show further details on
materials of construction, dimensions, operational
limits and flow performance.
Table 1: Materials of Construction
Filter media Glass microfiber
Media support Polyester
Components Polyester
Sealing Thermal Bonding
Table 2: Dimensions (nominal)
Outside Diameter 2.75” (70 mm)
Inside Diameter 1.25” (31 mm)
Effective Filtration Area 3.4 ft 2 (1.32 m 2 )
Lengths 10, 20, 30, 40 inches
(25.4, 50.8, 76.2, 101 cm)
Table 3: Operational Limits
Maximum Forward
Differential Pressure
60 psid (4.14 bar)
Maximum Reverse
Differential Pressure
30 psid (2.07 bar)
Maximum Operating
Temperature
180ºF (82ºC) at 10 psi
(0.69 bar) in water
Table 4: Flow Performance in Clean Water 1
1 Data based on 10” length filter
Additional Information
• GE filter cartridges are designed and manufac-
tured for resistance to a wide range of chemical
solutions. Conditions will vary with each appli-
cation and users should carefully verify chemi-
cal compatibility. Please contact your GE
distributor for more information.
• Table 5 provides ordering information on the
XPleat GF-T filters
psid mbar XPleat GF-T Pleated Filter