GE P&W E-Series Reverse Osmosis - E8 50 Hz User Manual
E8 series 50 hz, Reverse osmosis machine 9-23 cubic meters per hour, General properties

Fact Sheet
Find a contact near you by visiting www.gewater.com and clicking on “Contact Us”.
* Trademark of General Electric Company; may be registered in one or more countries.
©2013, General Electric Company. All rights reserved.
FS1130EN.doc Jul-13
E8 Series 50 Hz
Reverse Osmosis Machine 9-23 cubic meters per hour
Figure 1: E8 Series
When you mention reverse osmosis (RO), GE’s Water
& Process Technologies is the first name to come to
mind. Our E-series RO machines (Figure 1) are de-
signed for durable operation, high quality product
water production, easy installation and straightforward
control.
General Properties
Typical Applications
Process ingredient water
Safe drinking water
Boiler feed water
Ion exchange pre-treatment
Standard Economy Features
Energy saving 37.2 m
2
(400 ft
2
) membrane ele-
ments
SS high-pressure piping
1-micron pre-filter with SS housing
Automatic inlet shut-off valve
Accutrak RO microprocessor controller
-
Permeate and concentrate paddlewheel
flow sensors
-
Permeate conductivity sensor
-
Permeate tank level monitoring
-
SD card for collection of operating data
-
ALARMS: Low inlet pressure, high concentrate
pressure, high temperature, high permeate
conductivity, motor fault, and fill-time exceed-
ed
-
Remote machine on/off capability
Feed water flush on shut down
Panel-mounted pre-filter, post-filter, primary,
and final pressure gauges
Deluxe (DLX) Features – in addition to ECN features
Inlet pH sensor
Chemical dosing pump for antiscalant dosing or
pH adjustment
Clean-In-Place pump plumbed, wired and
mounted; remote tank
ALARMS:
Same
as
above
plus
high/
low pH, high permeate pressure
Table 1: Operating Parameters
Operating Pressure
14-15 bar
Maximum Recovery
75%
Nominal Rejection
95-98%
Operating Temperature
13-30
C (55-85
F)
Minimum Inlet Pressure
2 bar (30 psig)
Design Temperature
25
C (77
F)