GE P&W Spiral Wound Membranes - AD HR Series - Manual

Fact Sheet
AD HR Series
High Rejection Seawater RO Elements
The AD HR Series, family of proprietary thin film
reverse osmosis membrane elements, is character-
ized by an excellent sodium chloride rejection.
AD HR series is selected when high quality perme-
ate is demanded from seawater that is relatively
high in TDS.
AD HR series new membrane chemistry provides
excellent rejection characteristics when operated at
seawater operating conditions (pressures exceed-
ing 800psi (5,516kPa) and elevated seawater tem-
peratures.
Table 1: Element Specification
Membrane Thin-film membrane (TFM*)
Model
Average
permeate
flow gpd
(m3/day) 1,2
Average
NaCl
rejection 1,2
Minimum
NaCl
rejection 1,2
Minimum
Boron
Rejection 2
AD-90 1500 (5.7) 99.75% 99.3% 93.0%
AD-365 6000 (22.7) 99.75% 99.3% 93.0%
AD-400, 34 6500 (24.6) 99.75% 99.3% 93.0%
AD-440 7100 (26.9) 99.75% 99.3% 93.0%
1 Average salt rejection after 24 hours operation. Individual flow rate
may vary +25%/-15%.
2 Testing conditions: 32,000mg/l NaCl & 5mg/l boron solution at 800psi
(5,516kPa) operating pressure, 77°F (25°C), pH 8.0 and 7% recovery.
Model Active area
ft 2 (m 2 )
Outer wrap
Part
number
AD-90 90 (8.4) Fiberglass 3056651
AD-365 365 (33.9) Fiberglass 3056652
AD-400, 34 400 (37.2) Fiberglass 3056654
AD-440 440 (40.9) Fiberglass 3056655
Table 2: Operating and CIP parameters
3 SDI is measured on a non-linear scale using a 0.45 micron filter paper.
Additionally, finer colloids, particulates and microorganisms that pass
through the filter paper and not measured in the SDI test, will potential-
ly foul the RO element. For performance consistency and project war-
ranty, please use Winflows projection software and consult your Filters
with Membranes representative.
Typical Operating Pressure 800psi (5,516kPa)
Typical Operating Flux 7-11GFD (12-19LMH)
Maximum Operating Pressure 1,200psi (8,274kPa)
Maximum Temperature Continuous operation: 122°F (50°C)
Clean-In-Place (CIP): 122°F (50°C)
pH range Optimum rejection: 7.0-7.5,
Continuous operation 4.0-11.0,
Clean-In-Place (CIP): 2.0-11.5
Maximum Pressure Drop Over an element: 12 psi (83 kPa)
Per housing: 50 psi (345 kPa)
Chlorine Tolerance 1,000+ ppm-hours,
dechlorination recommended
Feedwater 3 NTU < 1
SDI < 5
Find a contact near you by visiting www.gewater.com and clicking on “Contact Us”.
* Trademark of General Electric Company; may be registered in one or more countries.
©2014, General Electric Company. All rights reserved.
FSpsADHRSeries_EN.doc Jan-14