GE P&W PRO AP Series 50 Hz - Manual

Find a contact near you by visiting www.ge.com/water and clicking on “Contact Us”.
* Trademark of General Electric Company; may be registered in one or more countries.
©2013, General Electric Company. All rights reserved.
AP-FSpwPRO_AP_Series_50Hz_EN.doc Apr-13
Fact Sheet
PRO AP Series 50 Hz
Reverse Osmosis Machines from 11 to 102 m 3 /hr
Basic Features
 1000 mg/L feed TDS and 20C water tempera-
ture design
 GE Intelligent Platforms' VersaMax Micro PLC
with 6-inch QuickPanel monochrome
touchscreen.
 Xylem SV high pressure pump
 Communication: RS232/DH485
 4-20 mA instrument display on instrument
center
Materials of Construction
High-pressure piping 316 SS, Sch. 10
Low-pressure piping PVC, Sch. 80
Frame Painted blue carbon steel
Enclosure IP54 (painted carbon steel)
Instrumentation
Flow Meters Permeate, concentrate
Conductivity Permeate
Pressure Pre-filter, post-filter, primary,
final, permeate, concentrate,
pump discharge
Pressure Switch Feed, permeate, concentrate
pH (Optional) Feed
ORP (Optional) Feed
Instrument Center Signet 8900
Options Available
 Premium controls and instrument package
 pH and ORP sensors added to Basic package
 Skid mounted motor starter (Wye-Delta) added
to basic package
 High Rejection Membrane Elements
 PRO Clean-in-Place units
 Allen Bradley PLC and HMI packages
 Grundfos CRN high pressure pump(s)
Documentation Included
 Operation and maintenance manual
 Drawings: piping and instrumentation, electri-
cal and general dimension
Operating Parameters
Design Recovery 1 75%
Design temp. 20ºC
Operating range 2 to 30ºC
Nominal rejection 97-99%
Design inlet pressure 2-4 bar
1 Recovery Rate can vary +/- 5%