Treatment and feeding requirements, General properties, Packaging information – GE P&W Boiler Water Treatment Chemicals - OptiSperse HP54674 User Manual
Page 2: Safety precautions
Page 2
Treatment and Feeding Requirements
Feed Point - Boiler steam drum via separate chemi-
cal feedline.
Feedrate - Sufficient OptiSperse HP54674 should be
fed to maintain the recommended boiler phosphate
residual. Feedrates depend upon operating pres-
sure, heat transfer rate, feedwater quality, and type
of fuel burned.
Dilution - Use good quality condensate, demineral-
ized water, or deaerated boiler feedwater to make a
convenient feeding strength. The material may be
fed neat (dilution slip stream recommended) or di-
luted in any proportion. If diluted, mild agitation
should be provided.
Equipment - OptiSperse HP54674 can be fed using
polyolefin tanks with stainless steel piping, pump
internals, fittings, and shut-off valves. Relief valves,
agitator shaft and propeller should be stainless
steel. Consult your GE representative for specific
information.
General Properties
Physical properties of OptiSperse HP54674 are
shown on the Material Safety Data Sheet, a copy of
which is available on request.
Packaging Information
OptiSperse HP54674 is a liquid blend, available in a
variety of containers and delivery methods. Contact
your GE representative for details.
Safety Precautions
A Material Safety Data Sheet containing detailed
information about this product is available upon
request.