GE P&W Pleated Filters - Memtrex PM Capsule Filters with Hydrophobic Polypropylene Membrane, Absolute - Manual (Page 2)

Page 2 FS1103EN
Table 2: Operational Limits
Table 3: Integrity Testing
Additional Information
Memtrex PM Capsule filters may be sanitized with a
variety of commonly used chemical agents. The
capsules may be repeatedly autoclaved (250°F
[121°C], 30 minutes) for up to 5 cycles.
GE Water & Process Technologies certifies that the
materials contained in its Memtrex PM Capsule fil-
ters meet U.S. FDA requirements for food contact
under the applicable regulations in 21 CFR. For fur-
ther information, contact the GE Technical Services
Department. Memtrex PM filters meet the test crite-
ria for USP class VI-121°C Plastics.
Figures 2, 3 and 4 show the test data results of flow
performance for the small, medium and large
Memtrex FE Capsule Filters using a 10-inch
length filter.
GE filter capsules are designed and manufactured
for resistance to a wide range of chemical solutions.
Conditions will vary with each application
and users should carefully verify chemical compati-
bility. Please contact your GE distributor for
more information.
Table 4: Ordering Information
Figure 2: Memtrex PM small capsule flow rate per-
formance in clean water. 2
Figure 3: Memtrex PM medium capsule flow rate per-
formance in clean water. 2
Figure 4: Memtrex PM large capsule flow rate perform-
ance in clean water. 2
2 Data based on 10 inch length filter
For more information
• Email: [email protected]
• Tel: 800-444-8212 USA
• Canada Tel: 952-988-6665
• Web: www.geosmolabstore.com