Additional information, For more information – GE P&W Pleated Filters - Flotrex AP Capsule with Polypropylene Microfiber Media, Nominal User Manual
Page 2

Table 2: Operational Limits
Additional Information
Flotrex-AP Capsule Filters may be sanitized with a
variety of commonly used chemical agents. The
capsule filters may be repeatedly autoclaved at
250ºF (121ºC) for up to five, 30-minute cycles.
GE certifies that the materials contained in the
Flotrex AP filters meet U.S. requirements for food
contact under the applicable regulations in 21 CFR.
For further information, contact the GE Technical
Services Department.
Figures 2, 3 and 4 show the test data results of flow
performance for the small, medium and large
Flotrex AP Capsule Filters using a 10-inch
length filter.
GE filter cartridges are designed and manufactured
for resistance to a wide range of chemical
solutions. Conditions will vary with each application
and users should carefully verify chemical compatibil-
ity. Consult the ordering information in Table 3 below
or contact your GE distributor for more information.
For more information
• Email: [email protected]
• Tel: 800-444-8212 USA
• Canada Tel: 952-988-6665
•
Figure 2: Flotrex AP small capsule flow performance in
clean water
1
Figure 3: Flotrex AP medium capsule flow performance
in clean water
1
Figure 4: Flotrex AP large capsule flow performance in
clean water
1
1.
Data Based on 10-inch length filter
Table 3: Ordering Information
Type
Absolute Micron Rating
Capsule Size
Connections
Housing style
CFAP
96 = 0.65µm
01 = 1.0µm
03 = 3.0µm
05 = 5.0 µm
10 = 10.0 µm
20 = 20.0 µm
40 = 40.0 µm
08 = small
27 = medium
52 = large
L = ¼”- ½" hose barb
M = 3/8" hose barb
R = ¼” NPT male
W = ½” NPT male
Y = 1.5" sanitary flange
Blank = Natural poly-
propylene
-O = Opaque polypro-
pylene (1/4in NPT con-
nection only)
Page 2
FS1073EN