Softening, Condensate polishing, General properties – GE P&W Mobile Water Treatment Systems - MobileFlow User Manual
Page 2: Further information

Page 2
FS1057EN
deoxygenate water from virtually any source,
including municipal, well, raw surface water,
condensate, and demineralized water. This
service is readily available on an emergency basis,
and is also typically utilized during by-pass of the
client’s deaerator for inspections and repairs.
Softening
The MobileFlow system provides softening at high
flow rates, routinely producing water at 600 GPM,
and can be reconfigured to produce 1,000 GPM
per trailer. Mobile and quickly available, this ap-
plication can be provided with either exchange
service off-site regeneration) or on-site regenera-
tion. A MobileFlow unit has a softening capacity in
excess of 15 million grains.
Condensate Polishing
Utilizing a cation/mixed bed configuration,
condensate can be polished to remove crud
loading and trace ionic contaminants during unit
start-ups or for longer-term requirements. The
10% cross-linked cation resin is strong enough to
withstand aggressive temperatures and crud
loads of the condensate while keeping the mixed
bed resins clean for final ionic contaminant
removal without interference.
General Properties
The MobileFlow system incorporates an exclusive piping
system linking six rubber-lined ASME code pressure
vessels. The international version (shown here) has three
axles and the U.S. version has two.
Dimensions and weights
Overall length
with tractor
60’-0”
Trailer length
43’-0”
Trailer height
13’-6”
Trailer width
8’-0”
Gross trailer
operating weight
90,000 lbs.
Electrical
Electrical power
requirements
110V, 20 amps
Specifications
Inlet/outlet
connections
2.5” NST, male fire hose, 3 inlet, 3 outlet
Also available: 4” 150 psi flange or 4” NST male fire
hose, 1 inlet, 1 outlet
Pressure vessels
6 per trailer, ASME code, 100 psi (7 bar) W.P.,
rubber lined
Resin capacity
Over 5 million grains (Demineralization)
Outlet resin trap
8” with suitable mesh element
Suitable media
Ion exchange resins, synthetic adsorbents,
activated carbon, granular filter media, etc.
Instrumentation
• Two conductivity meters, one with strip chart
recorder and alarm or telog recorder, with alarm
• High/Low temperature alarms
• Complete pressure instrumentation
• Rate of flow indicator
• Totalizing flow meter
Controls
• Adjustable pressure reducing valve on inlet
• Isolation valves on all pressure vessels
• Automatic shutdown system
• External audible alarms
Heating
Propane fueled, thermostat controlled system for
freeze protection to -20°F
Further Information
For more about the Emergency and other services
please call number below:
US toll free 800 446 8004 or
757-855 9000
MobileFlow Pressure Drop
at 60°F (16°C)
INFLUENT WATER TDS – mg/l as ions
Demineralizer Capacity