GE P&W Pleated Filters - Memtrex HFE-T - Polyester PTFE - Manual (Page 2)

Page 2 Fact Sheet
Table 2: Dimensions
Filter model Nominal O.D. Nominal I.D.
MHFE85-T
MHFE91-T
MHFE92-T
MHFE94-T
MHFE01-T 2.75” (70mm)
2.75” (70mm)
2.75” (70mm)
2.75” (70mm)
2.75” (70mm) 1.25” (31mm)
1.25” (31mm)
1.25” (31mm)
1.25” (31mm)
1.25” (31mm)
Table 3: Operational Limits
Maximum forward differential pressure
Maximum reverse differential pressure
Maximum operating temperature 60 psi (4.14 bar)
at 70°F (21.1°C)
30 psi (2.07 bar)
at 70°F (21.1°C)
205ºF (96.1ºC)
at 25 psid (1.7 bar)
Table 4: Flow Performance in CleanWater 1
1 Data based on 10” length filter
Integrity Testing
 0.05 μm  5 cc / min at 40 psig (2.76 bar)
 0.1 μm  5 cc / min at 40 psig (2.76 bar)
 0.2 μm  5 cc / min at 30 psig (2.07 bar)
 0.45 μm  5 cc / min at 20 psig (1.38 bar)
 1 μm  5 cc / min at 15 psig (1.38 bar)
Additional Information
 Memtrex HFE-T filters may be sanitized with
compatible chemical agents. The filters must
not be autoclaved or steam sterilized.
 GE certifies that the material contained in its
Memtrex HFE-T pleated filters meet U.S. FDA
requirements for food contact under the ap-
plicable regulations in 21 CFR. For further in-
formation, contact GE technical services.
Memtrex HFE-T filters meet the test criteria for
USP class VI-121°C Plastics.
 Aqueous extracts from Memtrex HFE-T filters
contain less that 0.25 EU/ml. The filters typical-
ly exhibit low levels of non-volatile residues.
 GE filter cartridges are designed and manu-
factured for resistance to a wide range of
chemical solutions. Conditions will vary with
each application and users should carefully
verify chemical compatibility. Please contact
your GE distributor for more information.
Table 5 provides additional ordering information. Table 5: Ordering Information
Type Absolute Micron
Rating
Nominal cartridge
Length
End #1 Adapter End #2 Adapter Elastomer material Product Grade
MHFE-T 85 = 0.05 µm
91 = 0.1 µm
92 = 0.2 µm
94 = 0.45 µm 1 = 10 in (25 cm)
2 = 20 in (51 cm)
3 = 30 in (76 cm)
4 = 40 in (102 cm) A = Open End
Gasket
E = 222 O-Ring
F = 226 O-Ring A = Open End
Gasket
E = Closed End Cap
H = Fin Adapter T = Teflon² Encap-
sulated Viton² E = Electronic grade
rinse
Pre Wet = Rinsed
and packed wet
²Teflon and Viton are a registered trademark of DuPont.