Warning, Fi g 6.1 – Peerless-AV IM760PU-S - Installation User Manual

Page 9

9 of 12

ISSUED: 12-04-07 SHEET #: 095-9279-8 (2013-10-01)

Notes:

• The number of fasteners used will vary,

depending upon the type of display.

• Multi-washers and spacers may not be

used, depending upon the type of display.

• Use the corresponding hole in the multi-

washer that matches your screw size.

MULTI-WASHER

SMALL HOLE FOR M4 SCREWS

• Tighten screws so display brackets are fi rmly attached to display. Do not tighten with excessive force.

Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing
screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly

secured, damage may occur to display or product may fail.

WARNING

MEDIUM HOLE FOR M5 SCREWS

LARGE HOLE FOR M6 SCREWS

Note: "X" dimensions should be equal.

CENTER BRACKETS

VERTICALLY ON BACK OF

DISPLAY

fi g 6.1

NOTE: For fl at back displays proceed to step 6-2. For bump-out or recessed back display skip to step 6-3

HOLE PATTERN

FOR USE WITH

UNIVERSAL

ADAPTER PLATE

LARGE
HOLES

Using the hole pattern shown in detail 1, attach the adapter plate to universal adapter
plate (T) with four M10 x 17mm screws (X) as shown. Tighten screws using 6mm al-
len wrench (Y).

Installing Universal Adapter Plate to Display

DETAIL 1

To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display.
Place display face side down. If display has knobs on the back, remove them to allow the adapter brackets to be
attached. Place adapter brackets (V) on back of display, align to holes, and center on back of display as shown in
fi gure 6.1. Attach the adapter brackets to the back of the display using the appropriate combination of screws,
multi-washers, and spacers as shown in fi gure 6.2 or fi gure 6.3.

NOTE: Top and bottom holes must always be used.

Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.

ADAPTER

PLATE

6-1