Peerless-AV IM760PU-S - Installation - Manual (Page 5)

5 of 12 ISSUED: 12-04-07 SHEET #: 095-9279-8 (2013-10-01)
In-wall box (B) can be installed between two 2" x 4"studs 16" off center. Use a stud fi nder to locate the edges of the
stud. Use of an edge-to-edge stud fi nder is highly recommended. Based on its edges, draw vertical lines down the
inside edges of stud’s. Mark desired center of display between studs. Draw a horizontal line above desired center
of display as indicated in fi gure 1.1 or 1.2. Draw a second horizontal line 16-5/8" (422mm) below this line to outline
wall opening between inside edges of studs. Remove drywall inside cut outline.
Installation to Wood Stud Wall
1
16-5/8"
(422mm)
14.5"
(368mm)
Center of display will be located
7-7/8" (200mm) below the top
cut line.
NOTE: Depending on mount
orientation shown in fi gure 1.3
in step 1-1, display center will
be 6.39" (162mm) from the
inside edge of stud.
NOTE: Depending on right
or left side mount orientation
shown in fi gure 1.3 in step 1-1,
display center will be 6.39"
(162mm) from the inside edge
of stud.
CENTER OF
ADAPTER PLATE
Center of adapter plate will be located 6"
(152mm) below the top cut line.
NOTE: Center of adapter plate may not
represent display center.
Placement of in-wall box will depend on
the display center and location of display
mounting holes in relation to adapter
plate.
NOTE: Depending on right or left side
mount orientation shown in fi gure 1.3
in step 1-1, display center will be 6.39"
(162mm) from the inside edge of stud.
Display center with models
IM760P and IM760P-S:
Display center with models
IM760PU and IM760PU-S:
6"
(152mm)
TOP CUT LINE
16-5/8"
(422mm)
14.5"
(368mm)
CENTER OF DISPLAY
7-7/8"
(200mm)
TOP CUT LINE
fi g. 1.1
fi g. 1.2
6.39"
(162mm)
8.11"
(206mm)
6.39"
(162mm)
8.11"
(206mm)