Caution, Warning, Adjustment of flat panel display – Peerless-AV IM760PU-S - Installation User Manual

Page 11: Fig. 7.1 fig. 7.2, Rear view top view

11 of 12

ISSUED: 12-04-07 SHEET #: 095-9279-8 (2013-10-01)

TILT Adjustment: Adjust tension knob on side of
mount to desired tension to enable tilt adjustment
and balance your display size and weight as
shown in fi gure 7.1. Push or pull from top or
bottom of display to adjust tilt as shown. The tilt
can be adjusted to a maximum of 10° forward or 5°
backward. Retighten tension knob.

ROLL Adjustment: Loosen M5 x 25mm screws
using 4mm allen wrench (K). Rotate display either
5° clockwise or counter-clockwise, level display
then tighten M5 x 25mm screws using 4mm allen
wrench (K) as shown in fi gure 7.2.

FOR VERTICAL HEIGHT ADJUSTMENT: Tighten
or loosen two M8 x 40mm screws an equal
number of turns to achieve ± 1" of vertical height
adjustment as shown in detail 1.

Adjustment of Flat Panel Display

TENSION
KNOB

M5 X 10MM

• Do not tighten screws with excessive force.

• Be careful not to pinch fi ngers when opening and

closing mount from the wall.

CAUTION

Fig. 7.1

Fig. 7.2

M8 X 40MM

Adjustment of Flat Panel Display

• M10 x 15mm screws (E) must be securly tightened

before changing orientation of wall arm assembly
(A). Failure to lock adapter bracket can cause
display to come off of mount.

WARNING

FOR PORTRAIT OR LANDSCAPE Display
ORIENTATION: Remove two M5 x 12mm screws,
one M5 x 6mm screw and rotation block from top of
tilt head as shown in top view and rear view. Gently
grasp sides of display and rotate display into portrait
or landscape position as shown and reinstall rotation
block with two M5 x 12mm screws and one M5 x
6mm screw. NOTE: M5 x 6mm screw required in
landscape orientation only.

REAR VIEW

TOP VIEW

ROTATION BLOCK

M5 X 12MM SCREWS

M5 X 6MM SCREWS

M5 X 12MM

SCREWS

M5 X 6MM

SCREWS