Fi g. 6.2 – Peerless-AV IM760PU-S - Installation User Manual

Page 10

10 of 12

ISSUED: 12-04-07 SHEET #: 095-9279-8 (2013-10-01)

Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into display as
shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

NOTE: Spacers may not be used, depending upon the type of display.

Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into
display as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three full turns into the display, select a longer length screw from the
baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

For Flat Back Display

For Bump-out or Recessed Back Display

SPACER

fi g. 6.2

6-2

6-3

ADAPTER BRACKET

(V)

DISPLAY

MULTI-WASHER

SCREW

If you have any questions, please call Peerless customer care at 1-800-865-2112.

fi g. 6.2

ADAPTER BRACKET

(V)

DISPLAY

MULTI-WASHER

SCREW